There’s nothing worse than getting into a cold shower in the morning and waiting for it to warm up. The delay in the arrival of the hot water is due to the distance it must travel from the hot water heater. To minimize this delay, we can use a hot water re-circulation system. By installing one of these systems, your family can enjoy instant hot water in the shower, the bathtub, and from any sinks along the plumbing run. In addition, these systems are known to prevent pipe freezing, save water and save energy because of the way they minimize waste of water, and the energy used to heat it. Installing a hot water recirculating system to your existing plumbing is surprisingly easy, and can be completed by the average homeowner in less than an hour.
We found the easiest Hot Water Re-circulation System to be the Hot Water Lobster Instant Hot Water Valve because it does not require a water pump, electrical hook ups, pipe cutting, or pipe soldering and is also eco-friendly.
Things You’ll Need: an Adjustable Wrench, a Screw Driver, a Towel and a hot water recirculating valve kit.
1. Locate the plumbing fixture that is farthest from your hot water heater. Installing the valve at this fixture will minimize energy waste while maximizing hot water to all the fixture along the plumbing circuit .
2. Turn off both the water supply valves to the fixture (hot and cold water valves at the fixture you have selected for installation).
3. Remove the existing water lines that connect the hot and cold shut-off valves to your faucet.
4. Install the hot water re-circulation valve by: connecting one end of the flexible cold water line (supplied with your kit) to your cold water shut-off valve and the other end to the cold water side of your faucet; and by connecting one end of the flexible hot water line (supplied with your kit) to your hot water shut-off valve and the other end to the hot water side of your faucet. These connections are screw together-type connections and self sealing (not requiring soldering or pipe compound).
5. Set the control knob to your desired temperature and turn on your hot and cold supply lines. That’s it…you now have instant hot water at your fixtures.