Get Faster Hot Water with your Current Water Heater

You turn the hot water faucet on and wait. And wait some more. And then after a couple of minutes hot water finally emerges from the faucet. Meanwhile all that precious water was wasted running down the drain. This process is repeated for countless showers, baths, dishes, laundry and other daily tasks all across the country every day. The average household wastes around 46 gallons a day or almost 17,000 gallons of water a year! This waste also results in increased sewerage bills, which are usually based on water consumption.

If only you had an easy way have instant hot water whenever you wanted it.

Well with new-patented technology there’s a way you can have instant hot water out of all your faucets for under $200.00? By simply installing a hot water recirculation valve at the fixture near the end of your hot water plumbing run. These easy to install, economical devices provide instant hot water for all your faucets and showers. This new technology uses your existing water pipes and the thermal convection generated by your water heater to circulate the water back to your water heater for reheating (not requiring a pump or any electricity). These systems have a temperature-controlled valve that allows the consumer to easily adjust the temperature control knob to meet their particular needs. It also can prevent pipe freezing. There is no water waste, and it also minimizes energy waste since it only re-circulates water when the hot water at your faucet cools below your desired temperature. Installation is a simple DIY 15-minute project (not requiring any pipe cutting, soldering or electrical connections).

This entry was posted in Environmental and tagged , , , , , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply